Servo with new hole drilled and test fit with linkage. When you drill the new hole pair up the servo horns and drill them together so they are exactly the same.

The linkage uses a Z bend and a plastic clevis. The servo arm needed to be positioned facing rear so all the linkage would fit under the servo cover properly.

Servo bonding:

  • Program your radio first
  • Center the servos and position the servo arms straight up and make sure both sides are the same!
  • Power up the model and tape the aileron in neutral.
  • Attach the linkage to the servo and flip the servo over.
  • Mix up a small batch of 5min epoxy and epoxy each servo in position and let cure!

P1000103